Power Supply Exchange 15" Flat Panel iMac
"Carefully ease the base towards you to detach it from the body of the iMac. There will be wires attached to the base, I recommend you disconnect the majority of them to reduce the clutter. At this point you need to remove the optical drive assembly as the power supply is above it. Use your Torx-10 screwdriver for this task. In the picture below, the two screws on the far right secure the EMI shield, it also has a strip of copper tape that holds it on the optical drive. I prefer to release all screws and remove the drive assembly with the EMI shield in place, if it makes it easier for you to remove it from the optical drive simple peel the tape off and reapply when reinstalling everything."
(Submitted by Noel Wed Jun 16, 2004 )
Our content can be syndicated: Main page Mac Page
Copyright 1999-2005 Noel Davis. Noel also runs web sites about sailing and kayaking.
All trademarks are the property of their owners.
All articles are owned by their author